Forum

Kevlar skin upper surface:OK I've made my first mistake, being too skimpy with the excess when cutting out the Kevlar. Kevlar is expensive so I though...

Equipment recesses:On a flying wing, to decide on equipment positions to minimize additional balancing ballast, it is best to assemble the entire mode...

Slots for Wing Spars:1. Scribe 2 lines 1/16” apart along each spar position on the wings lower surface.2. With a piece of tape as a depth gauge on a m...

Wing Spar Design:I considered the following:a) The Kevlar skin provides significant structural strength and durability so the need for a wing spar at ...

Wing LE

Elevon hinges:The elevon hinges will be the Kevlar lower skin. However Kevlar skin at the hinges can de-laminate over time with flexing of the hinge. ...

Early build pics cont.

Early build pics

I could not get the message editor to add a 2nd picture in the last post, so here it is.

A good and quite breezy contest was enjoyed by all 7 participants. Werner joined us around lunchtime for awhile to shoot the breeze, but it only had t...

Just another reminder LSF #4 is this Thursday 11th August. Current forecast looks OK though slightly on the breezy side, 20 km/h.Andy

Isn't the $15 just for the USB cable, not the simulator itself, which is $219?I recently purchased Phoenix because it works off the shelf with most tr...